OEM Restraints System Part Replacement Search

2023 Mazda CX-30

Print

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

1. Switch the ignition to off
2. Disconnect the negative battery cable
3. Wait for 1 minute or more to allow the backup power supply of the SAS control module to deplete its stored power

REV: 02/2023

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

• Deployed airbags: [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL; AIRBAG & SEAT ASSY,FRT; AIRBAG,ROOF]

• Replace the SAS control module with a new one, once the air bags and pre-tensioner seat belts have operated (deployed) due to a collision or other causes [MODULE,AIRBAG CONTROL]

• When replacing the passenger-side air bag module [AIRBAG, INSTRUMENT PNL] after the deployment, replace it together with the mid-wiring harness.

• After a side air bag has operated (deployed), always replace both the side air bag module and the seat back (pad, frame, trim) with new parts. [AIRBAG & SEAT ASSY,FRT]

• Once the air bags and pre-tensioner seat belts have operated (deployed) due to a collision or other causes, the crash zone sensor must be replaced with a new one even if the used one does not have any visible external damage or deformation [AIRBAG SENSOR,FRONT]

• Once the air bag has operated (deployed) due to a collision or other causes, the pressure sensor must be replaced with a new one even if the used one does not have any visible external damage or deformation [AIRBAG SENSOR,FRT DOOR]

• Once the air bag has operated (deployed) due to a collision or other causes, the side air bag sensor must be replaced with a new one even if the used one does not have any visible external damage or deformation [AIRBAG SENSOR,QTR PANEL]

• Replace the seat belt once the load limiter operates

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

Air Bag Module Inspection:
• Always use the on-board diagnostic function to diagnose the air bag module for malfunctions

Seatbelt assembles

Pre-tensioner Seat Belt Inspection:
• Always use the on-board diagnostic function to diagnose the pre-tensioner seat belt for malfunctions

Lap Pre-tensioner Seat Belt Inspection:
• Always use the on-board diagnostic function to diagnose the lap pre-tensioner seat belt for malfunctions.

• Perform the seat weight sensor inspection using the M-MDS
• Seat belt assemblies

Additional Information