OEM Restraints System Part Replacement Search
2018 Toyota Corolla
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
Before using an electric welder on the vehicle, remove any SRS parts around the area being repaired.Before repairs, remove the airbag sensor assemblies if impacts are likely to be applied to the sensor during repairs
1. Turn ignition switch to OFF and remove key.
2. Disconnect and isolate negative battery cable.
3. Wait at least 90 seconds.
REV: 09/2018
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
When the SRS parts are deployed (including when only an airbag or pretensioner is deployed) due to a collision, be sure to replace all sensors in the damaged areas (anywhere in need of repair) and airbag sensor assembly (center airbag sensor assembly). [AIRBAG SENSOR,FRONT, AIRBAG SENSOR,FRT DOOR, AIRBAG SENSOR,SIDE, AIRBAG SENSOR,QTR PANEL, MODULE,AIRBAG CONTROL][Replace deployed airbags]
• Horn button assembly [AIRBAG,STEERING WHEEL]
• Lower No. 1 instrument panel airbag assembly [AIRBAG,KNEE BOLSTER]
• Instrument panel passenger airbag assembly [AIRBAG,INSTRUMENT PNL]
• Curtain shield airbag assemblies [AIRBAG,ROOF]
• Front seat airbag assemblies [AIRBAG,FRONT SEAT BACK]
• Front seat airbag sub-assembly RH [AIRBAG,FRT SEAT CUSHION]
• If the front seat airbag assembly was deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage. [AIRBAG,FRONT SEAT BACK]
• If the front seat airbag sub-assembly RH was deployed, replace the front seat airbag sub-assembly RH, front seat adjuster sub-assembly RH, separate type front seat cushion pad RH and separate type front seat cushion cover RH with the necessary parts in accordance with the extent of the collision damage. [AIRBAG,FRT SEAT CUSHION]
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
Visually check the airbag sensors in undamaged areas for defects.If any defects are found or an airbag sensor has detected a major collision, replace the airbag sensor with a new one.
• Airbag sensor assembly (center airbag sensor assembly) [MODULE,AIRBAG CONTROL]
• Front airbag sensors [AIRBAG SENSOR,FRONT]
• Door side airbag sensors [AIRBAG SENSOR,FRT DOOR]
• Side airbag sensor assemblies [AIRBAG SENSOR,SIDE]
• Rear airbag sensors [AIRBAG SENSOR,QTR PANEL]
• Horn button assembly [AIRBAG,STEERING WHEEL]
• Lower No. 1 instrument panel airbag assembly [AIRBAG,KNEE BOLSTER]
• Instrument panel passenger airbag assembly [AIRBAG,INSTRUMENT PNL]
• Curtain shield airbag assemblies [AIRBAG,ROOF]
• Front seat airbag assemblies [AIRBAG,FRONT SEAT BACK]
• Front seat airbag sub-assembly [AIRBAG,FRT SEAT CUSHION]
• Front seat outer belt assemblies
• OCS
• Perform zero point calibration and sensitivity check
| Additional Information |