OEM Restraints System Part Replacement Search
2016 Mercedes-Benz AMG GT
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
Before beginning with:• bodywork
• work on airbag or ETR units (removal, installation)
• work on components that are associated with the airbag and emergency tensioning retractor units or require access to their electric circuit, e.g. when removing the steering wheel:
1) Disconnect/insulate ground line from battery
Before commencing welding work:
1. Remove ignition key or transmitter key
2. Disconnect and isolate ground line at the battery
After completion of work on airbags and emergency tensioning retractors:
• The supplemental restraint system must always be tested with a diagnosis system.
REV: 09/2020
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
The generated gas flow deploys the airbag or tensions the belt strap (if equipped). Defective or damaged pyrotechnical components • must always be replaced:The following pyrotechnical components can be installed in a range of versions and quantities (depending on the equipment installed).
• Driver airbag [AIRBAG,STEERING WHEEL]
• Front passenger airbag [AIRBAG,INSTRUMENT PNL]
• Sidebag [AIRBAG,FRONT SEAT]
• Seat cushion airbag
• Window airbag [AIRBAG,ROOF]
• Headbag
• Kneebag [AIRBAG,KNEE BOLSTER]
• Pelvis airbag
• Emergency tensioning retractor with and without belt airbag
• Buckle emergency tensioning retractor
• Belt anchor fitting tensioner
• Pyrotechnical fuse (pyrofuse)
• Roll bar trigger capsule
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
Pyrotechnical components are to be checked for external damage and replaced if necessary.If axial play or a noise is detected at the steering column tube, this must always be replaced.
Defective or damaged pyrotechnical components, control units and their sensor systems must always be replaced. Repair of or tampering with such components is not permissible.
Components that come into contact with pyrotechnical components (e.g. instrument panel, door trim, glove compartment, seats, wiring harnesses, belt straps, etc.) must always be checked for damage and be replaced if necessary. Only technically approved component combinations are permissible.
Damaged or defective attachment or bolting points of pyrotechnical components must be properly repaired or replaced.
| Additional Information |