OEM Restraints System Part Replacement Search

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

1. Turn ignition switch to OFF
2. Disconnect the negative cable from the battery
3. Wait at least 3 minute

Before removing any of the SRS parts (including the disconnection of the connectors), always disconnect the SRS connector

REV: 02/2016

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

When the front airbag(s) deployed after a collision, replace the following items:
• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL]
• Seat belt pretensioner(s)
• Front impact sensors [AIRBAG SENSOR,FRONT]
• SRS wiring harnesses
• Replace the crash pad which is damaged while Passenger Airbag (PAB) is deployed

When the side/curtain airbag(s) deployed after a collision, replace the following items:
• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG & SEAT BACK ASSY; AIRBAG,ROOF]
• Side impact sensor(s) for the deployed side(s) [AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,QTR PANEL]
• SRS wiring harnesses
• When the front side airbag deployed after a collision, replace the seatback as an assembly

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

Before doing any SRS repairs, use the Hi-Scan Pro/GDS to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs.

• Steering wheel
• Inspect the clock spring for heat damage
• Airbag connectors
• If any damage found, or problem with the occupant detection, replace the Passenger seat with PODS system
• After the vehicle is completely repaired, confirm the SRS airbag system is OK