OEM Restraints System Part Replacement Search
2015 Honda Pilot
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
Before disconnecting the SRS unit connectors, always disconnect the appropriate SRS parts connectors.1. Always turn the ignition switch to LOCK (0)
2. Disconnect the negative cable from the battery
3. Wait at least 3 minutes
REV: 10/2014
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
After a collision where the seat belt tensioners deployed, replace these items:• SRS unit [MODULE,AIRBAG CONTROL]
• Seat belt tensioners
• Front impact sensors [AIRBAG SENSOR,FRONT]
After a collision where the front airbag(s) deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL]
• Seat belt tensioners
• Front impact sensors [AIRBAG SENSOR,FRONT]
After a collision where the side airbag(s) deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Side impact sensor(s) (first) [AIRBAG SENSOR,SIDE]
• Side impact sensor(s) (second) [AIRBAG SENSOR,QTR PANEL]
• Side impact sensor(s) (third) [AIRBAG SENSOR,FLOOR]
• Rear safing sensor
• B-pillar lower trim
• Seat frame and related parts. After a collision where the side airbag was deployed, replace the side airbag and the seat frame and related parts with new parts. If the seat-back cushion is split, it must be replaced. [AIRBAG,FRONT SEAT]
• Seat belt tensioners
After a collision where a side curtain airbag has deployed, replace the items for the side(s) that deployed:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side curtain airbag(s) [AIRBAG,ROOF]
• Seat belt tensioner(s) for the side(s) that deployed
• Side impact sensor(s) (first) [AIRBAG SENSOR,SIDE]
• Side impact sensor(s) (second) [AIRBAG SENSOR,QTR PANEL]
• Side impact sensor(s) (third) [AIRBAG SENSOR,FLOOR]
• Rear safing sensor [AIRBAG SENSOR,FLOOR]
• Roof trim (headliner)
• A-pillar trim
• B-pillar upper trim
• C-pillar trim
• Upper quarter window trim
• D-pillar trim
• Front grab handle
• Rear grab handle
• All related trim clips
• Sunvisor
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• Before doing any SRS repairs, check for DTCs, for the less obvious deployed parts (seat belt tensioners, front impact sensors, side airbag sensors, etc.)• If there is a breaking or damage found in harness relevant to the replacement parts shown below, replace it, do not repair
• Do not replace the ODS unit unless it is physically damaged or a specific fault was found during DTC troubleshooting. Because it could complicate troubleshooting other DTCs
• After a vehicle collision, do the ODS unit operation check
• After a vehicle collision, inspect the front seat active head restrains
• After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace the components as needed.
• Inspect the cable reel for heat damage. If there is any damage, replace the cable reel
| Additional Information |