PrintDISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Turn ignition switch OFF.2. Disconnect the negative cable from the battery.
3. Wait at least 3 minutes before beginning work.
Before removing any of the SRSCM parts (including the disconnection of the connectors), always disconnect the SRSCM connector.
REV: 09/2019
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
When the front airbag(s) deployed after a collision, replace the following items:• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL]
• Seat belt pretensioner(s)
• Anchor pretensioner(s)
• Front impact sensors [AIRBAG SENSOR,FENDER]
NOTE: Replace the crash pad which is damaged while passenger airbag (PAB) is deployed
When the side/curtain airbag(s) deployed after a collision, replace the following items:
• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG & SEAT BACK ASSY; AIRBAG,ROOF] When the front side airbag deployed after a collision, replace the seat back as an assembly
• Side impact sensor(s) for the deployed side(s) [AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,SIDE]
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• Steering wheel• Inspect the clock spring for heat damage. If any damage found, replace the clock spring
• WCS reset and accuracy check
• After the vehicle is completely repaired, confirm the SRS airbag system is OK.