OEM Restraints System Part Replacement Search
2013 Honda Civic Sedan
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
Before doing any SRS repairs, check for DTCs with the HDS for the less obvious deployed components (front seat belt tensioners, front impact sensors, side impact sensors, etc).Before disconnecting the SRS unit connectors, always disconnect the appropriate SRS parts connectors.
1. Turn the ignition to LOCK (0)
2. Disconnect the negative cable from the 12 volt battery
3. Wait at least 3 minutes before starting work
REV: 02/2015
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
USA and Canada models: After a collision where the driver's seat belt outer lap tensioner deployed, replace these items:• SRS unit [MODULE,AIRBAG CONTROL]
• Front seat belt(s)
• Driver's seat belt outer lap tensioner
• Front impact sensor(s) [AIRBAG SENSOR,FRT BMPR]
After a collision where the front airbag(s) deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed front airbag(s) [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL]
• Front seat belt(s)
• Driver's seat belt outer lap tensioner (4-door USA and Canada models)
• Front impact sensor(s) [AIRBAG SENSOR,FRT BMPR]
After a collision where a seat side airbag deployed, replace the items for the side(s) that deployed:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side airbag(s) [AIRBAG,FRONT SEAT]
• Front seat belt(s)
• Side impact sensor(s) (first) [AIRBAG SENSOR,SIDE]
• Side impact sensor(s) (second) [AIRBAG SENSOR,QTR PANEL]
• B-pillar lower trim (4-door)
• Seat frame and related parts
Note: If the seat-back cover is split, it must be replaced
After a collision where a side curtain airbag deployed, replace the items for the side(s) that deployed:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side curtain airbag(s) [AIRBAG,ROOF]
• Front seat belt(s), for the side(s) that deployed
• Side impact sensor(s) (first) [AIRBAG SENSOR,SIDE] for the side(s) that deployed
• Side impact sensor(s) (second) for the side(s) that deployed [AIRBAG SENSOR,QTR PANEL]
• A-pillar trim
• B-pillar upper trim
• Quarter pillar trim (2-door)
• C-pillar trim (4-door)
• Front grab handle
• Rear grab handle (4-door)
• All related trim clips
• Sunvisor
• Headliner
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• If the harness is broken or damaged in the areas relevant to the replacement [SRS] parts, replace the harness, do not repair it.• Inspect all the SRS wire harnesses. Replace, do not repair, any damaged harnesses
• Before doing any SRS repairs, check for DTCs with the HDS for the less obvious deployed components (front seat belt tensioners, front impact sensors, side impact sensors, etc).
• Do not replace the ODS unit (USA and Canada models) or the OPDS unit (Mexico models) unless it is physically damaged or a specific fault was found during DTC troubleshooting because it could complicate troubleshooting other DTCs
• USA and Canada models: After a vehicle collision, do the front passenger's weight sensor unit operation check.
• After a vehicle collision, inspect the front seat active head restraints.
• Inspect the cable reel for heat damage. If there is any damage, replace the cable reel. [CLOCK SPRING]
• After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace the components as needed.
| Additional Information |