OEM Restraints System Part Replacement Search
2012 Honda Fit
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
Before disconnecting the SRS unit connectors, always disconnect the appropriate SRS parts connectors.1. Turn the ignition switch to LOCK (0)
2. Disconnect the negative cable from the battery
3. Wait at least 3 minutes before starting work
REV: 03/2013
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
After a collision where the seat belt tensioners deployed, replace these items:• SRS unit [MODULE,AIRBAG CONTROL]
• Seat belt tensioner(s)
• Front impact sensor(s) [AIRBAG SENSOR,FRONT]
After a collision where the front airbag(s) deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed front airbag(s) [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL]
• Seat belt tensioner(s)
• Front impact sensor(s) [AIRBAG SENSOR,FRONT]
After a collision where the side airbag(s) deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side airbag(s) [AIRBAG,FRONT SEAT]
• Side impact sensor(s) (first) [AIRBAG SENSOR,SIDE]
• Side impact sensor(s) (second) [AIRBAG SENSOR,QTR PANEL]
• B-pillar lower trim
• Front seat assembly (impact side) [sold as individual parts] After a collision where the side airbag was deployed, replace the side airbag and the seat frame and related parts with new parts. If the seat-back cushion is split, it must be replaced
• Seat belt tensioner(s)
After a collision where a side curtain airbag deployed, replace the items for the side(s) that deployed:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side curtain airbag(s) [AIRBAG,ROOF]
• Seat belt tensioner(s)
• Side impact sensor(s) (first) [AIRBAG SENSOR,SIDE]
• Side impact sensor(s) (second) [AIRBAG SENSOR,QTR PANEL]
• Roof trim [HEADLINER]
• A-pillar trim
• B-pillar upper trim
• Quarter pillar trim
• Front grab handle
• Rear grab handle
• All related trim clip(s)
• Sunvisor
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• Before doing any SRS repairs, check for DTCs, for the less obvious deployed parts (seat belt tensioners, front impact sensors, side airbag sensors, etc.)• Do not replace the ODS unit unless it is physically damaged or a specific fault was found during DTC troubleshooting. Because it could complicate troubleshooting other DTCs
• After a vehicle collision, inspect the front seat active head restrains
• Inspect all the SRS wire harnesses. Replace, do not repair, any damaged harnesses
• Inspect the cable reel for heat damage. If there is any damage, replace the cable reel
• Front Passenger's Weight Sensor Output Check
• After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace the components as needed.
| Additional Information |