OEM Restraints System Part Replacement Search
2012 Hyundai Sonata Hybrid
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
1) Turn the ignition switch OFF2) Disconnect negative battery cable from battery.
3) Wait at least 3 minutes before beginning work.
Before removing any of the SRSCM parts (including the disconnection of the connectors), always disconnect the SRSCM connector.
General Safety Information and Caution: This hybrid system uses a DC 270V voltage system. Be sure to follow safety instructions. Failure to follow safety instructions may result in serious injury or electrocution.
A caution label for high voltage is attached to the high voltage components. The color of the high voltage cables and connectors are orange. Do not touch any of these high voltage components, cables, and connectors without proper Personal Protection Equipment (PPE).
• For your safety when servicing the hybrid vehicle :
• Wear Personal Protection Equipment (Insulation Gloves and Safety Glasses).
• Do not carry any metallic object (watch, ring etc.) which can cause short circuit.
• Use insulated tools
• Before wearing the protective gear, make sure that they are not torn or broken and free of moisture.
REV: 06/2014
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
When the front airbag(s) deployed after a collision, replace the following items:• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL]
• Seat belt pretensioner(s)
• Anchor pretensioner(s)
• Front impact sensors [AIRBAG SENSOR,FRONT]
• SRS wiring harnesses
• Replace the crash pad which has been damaged after the passenger airbag (PAB) [AIRBAG,INSTRUMENT PNL] has been deployed
When the side/curtain airbag(s) deployed after a collision, replace the following items:
• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG & SEAT BACK ASSY; AIRBAG,ROOF]
• Side impact sensor(s) for the deployed side(s) [AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,SIDE]
• SRS wiring harnesses
• The side airbag cannot be disassembled from the seat back assembly, so replace the seat back assembly when replacing the side airbag [AIRBAG & SEAT BACK ASSY]
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• Before doing any SRS repairs, use the GDS Pro to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs.• When the front airbag(s) deployed after a collision, Inspect the clock spring for heat damage. If any damage found, replace the clock spring
• Steering wheel
• Weight Classification System (WCS) reset and accuracy check
| Additional Information |