OEM Restraints System Part Replacement Search
2012 Toyota Avalon
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
WARNING! The SRS is equipped with a backup power source, so that if work is started within 90 seconds after disconnecting the negative (-) terminal cable of the battery, the SRS may be deployed1. Turn engine switch off.
2. Disconnect and isolate negative battery cable.
3. Wait 90 seconds.
REV: 06/2012
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
Deployed front airbag(s):• Steering pad [AIRBAG,STEERING WHEEL]
• Front passenger airbag assembly [AIRBAG,INSTRUMENT PNL]
• Driver side knee airbag assembly [AIRBAG,KNEE BOLSTER]
• Front passenger side knee airbag assembly [AIRBAG,KNEE BOLSTER]
• Center airbag sensor assembly [AIRBAG MODULE,INTERIOR]
• The front airbag sensor on the impacted side should be replaced after the steering pad, front passenger airbag assembly or driver side knee airbag assembly has deployed. [AIRBAG SENSOR,FENDER]
Deployed side airbag(s):
• Front seat airbag assembly [AIRBAG & SEAT ASSY,FRT]
• Center airbag sensor assembly [AIRBAG MODULE,INTERIOR]
• The side airbag sensor on the impacted side should be replaced after the front seat airbag assembly and/or curtain shield airbag assembly have deployed [AIRBAG SENSOR,SIDE]
Deployed side curtain airbag(s):
• Curtain shield airbag assembly [AIRBAG,ROOF]
• Center airbag sensor assembly [AIRBAG MODULE,INTERIOR]
• The side airbag sensor on the impacted side should be replaced after the front seat airbag assembly and/or curtain shield airbag assembly have deployed [AIRBAG SENSOR,SIDE]
• The rear airbag sensor on the impacted side should be replaced after the curtain shield airbag assembly has deployed [AIRBAG SENSOR,QTR PANEL]
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
Perform a diagnostic system check• Steering pad [AIRBAG,STEERING WHEEL]
• Front passenger airbag assembly
• Driver side knee airbag assembly [AIRBAG,KNEE BOLSTER]
• Front passenger side knee airbag assembly [AIRBAG,KNEE BOLSTER]
• Front Airbag Sensor [AIRBAG SENSOR,FENDER]
• Side Airbag Sensor [AIRBAG SENSOR,SIDE]
• Rear Airbag Sensor [AIRBAG SENSOR,QTR PANEL]
• Front seat inner belt assembly
• Seat position sensor
• Front seat side airbag assembly [AIRBAG & SEAT ASSY,FRT]
• Curtain shield airbag assembly [AIRBAG,ROOF]
• Front seat outer belt assembly
• Rear seat outer belt assembly
• Instrument panel/ Instrument panel reinforcement
• Front pillar garnish
• Occupant Classification ECU
• Occupant Classification precaution, Check the flatness of the body side that is equipped with the passenger seat
• Headliner
• Attaching points and hardware
• SRS wire harnesses or connectors
• Seatbelts and seatbelt mounting points
• Seats and seat mounting points
• Replace the faulty parts of the seat belt systems (outer belt, inner belt, bolts, nuts, adjustable shoulder anchor, tether anchor hardware, sill-bar, etc.)
• Seat belt systems not in use at the time of a collision should also be inspected and replaced if found to be damaged or working improperly
| Additional Information |