OEM Restraints System Part Replacement Search
2012 Honda Accord Coupe
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
Before disconnecting the SRS unit connectors, always disconnect the appropriate SRS parts connectors.1. Always turn the ignition switch to LOCK (0)
2. Disconnect the negative cable from the battery
3. Wait at least 3 minutes before starting work
REV: 05/2012
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
After a collision where the seat belt tensioners deployed, replace these items:• SRS unit [MODULE,AIRBAG CONTROL]
• Front seat belt(s)
• Front impact sensors [AIRBAG SENSOR,FENDER]
After a collision where the front airbag(s) deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed front airbag(s)
[AIRBAG, STEERING WHEEL], if deployed
[AIRBAG, INSTRUMENT PNL], if deployed
• Front seat belt(s)
• Front impact sensor(s) [AIRBAG SENSOR,FENDER]
After a collision where the side airbag(s) deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side airbag(s)
• Front seat belt(s)
• Side impact sensor(s) (first) [AIRBAG SENSOR,INTERIOR]
• Side impact sensor(s) (second) [AIRBAG SENSOR,QTR PANEL]
• Seat frame and related parts
After a collision where the side airbag was deployed, replace the side airbag and the seat frame and related parts with new parts. If the seat-back cushion is split, it must be replaced.
After a collision where a side curtain airbag has deployed, replace the items for the side(s) that deployed:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side curtain airbag(s) [AIRBAG,ROOF]
• Front seat belt(s)
• Side impact sensor(s) (first) [AIRBAG SENSOR,INTERIOR]
• Side impact sensor(s) (second) [AIRBAG SENSOR,QTR PANEL]
• Rear safing sensor [AIRBAG SENSOR,INTERIOR]
• Roof trim (headliner)
• A-pillar trim
• B-pillar upper trim (4-door)
• C-pillar trim
• Front grab handle
• Rear grab handle (4-door)
• All related trim clips
• Sunvisor
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• If there is a breaking or damage found in harness relevant to the replacement parts shown below, replace it, do not repair• Before doing any SRS repairs, check the DTCs with the HDS, for the less obvious deployed components (front seat belt tensioners, front impact sensors, side impact sensors, rear safing sensor).
• Do not replace the ODS unit unless it is physically damaged or a specific fault was found during DTC troubleshooting. Because it could complicate troubleshooting other DTCs.
• After a vehicle collision, do the ODS unit operation check
• After a vehicle collision, inspect the front seat active head restraints
• Inspect all the SRS wire harnesses. Replace, do not repair, any damaged harnesses.
• Inspect the cable reel for heat damage. If there is any damage, replace the cable reel
• Front Passenger's Weight Sensor Output Check
• Do not repair a torn or frayed seat-back cover/pad. Replace the seat-back cover/pad if it is damaged
• After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace the components as needed.
| Additional Information |