OEM Restraints System Part Replacement Search

2012 Toyota Yaris Sedan

Print

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

When troubleshooting the SRS, always inspect DTCs before disconnecting the battery.

Before using an electric welder on the vehicle, remove any SRS parts around the area being repaired

1. Turn ignition switch OFF
2. Disconnect negative (-) cable
3. Wait at least 90 seconds

REV: 04/2012

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

When the SRS parts are deployed (including when only an airbag or pretensioner is deployed) due
to a collision, be sure to replace all sensors in the damaged areas (anywhere in need of repair) and
airbag sensor assembly. [AIRBAG SENSOR,FRONT; AIRBAG SENSOR,SIDE; AIRBAG SENSOR,QTR PANEL; MODULE,AIRBAG CONTROL]

• Driver's Airbag [AIRBAG,STEERING WHEEL], [if deployed]
• Passenger airbag assembly [AIRBAG,INSTRUMENT PNL], [if deployed]
• Front seat side airbag [AIRBAG & SEAT ASSY,FRT], [if deployed]
• Curtain shield airbag assembly [AIRBAG,ROOF], [if deployed]

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

Even in the case of a minor collision when the SRS does not deploy, the following parts should be inspected. If a defect is found (e.g. cracks, dents or any other defects) in any of the housings, brackets or connectors, then replace the part with a new one.

• Steering pad
• Front passenger airbag assembly
• Center airbag sensor assembly
• Front airbag sensor
• Front seat inner belt assembly
• Seat position sensor
• Occupant classification ECU
• Front seat side airbag assembly
• Side airbag sensor
• Curtain shield airbag assembly
• Rear airbag sensor
• Front seat outer belt assembly
• Front pillar garnish and roof headlining
• Instrument Panel




Additional Information