OEM Restraints System Part Replacement Search
2012 Acura RDX
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
Before doing any SRS repairs, use the HDS SRS menu method to check for DTCs; refer to the DTC Troubleshooting Index for the less obvious deployed parts (seat belt tensioners, front impact sensors, side airbag sensors, etc.)Make sure you have the anti-theft code(s) for the audio and/or the navigation system (if equipped)
Before removing any of the SRS parts (including the disconnection of the connectors), always disconnect the associated SRS connector. Review the SRS component locations and the precautions and procedures before doing repairs or service.
1. Turn the ignition switch to LOCK (0)
3. Disconnect the negative cable from the battery
4. Wait at least 3 minutes before beginning work
REV: 01/2012
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
After a seat belt tensioner deployment:• SRS unit [MODULE,AIRBAG CONTROL]
• Seat belt tensioners
• Seat belt buckle tensioners
• Front impact sensors [AIRBAG SENSOR,FENDER]
After a collision where the front airbag(s) deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL]
• Seat belt tensioners
• Seat belt buckle tensioners
• Front impact sensors [AIRBAG SENSOR,FENDER]
• Dashboard, if Instrument Panel Airbag Deployed
After a collision where the side airbag(s) deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side airbag(s) [AIRBAG,FRONT SEAT]
• Side impact sensor(s) (First) [AIRBAG SENSOR,SIDE]
• Side impact sensor(s) (second) [AIRBAG SENSOR,QTR PANEL]
• B-pillar lower trim
• Seat frame and related parts, with deployed side seat airbag
• Side airbag bracket
• Seat belt tensioners
• Seat belt buckle tensioners
After a collision where a side curtain airbag has deployed, replace the items for the side(s) that deployed:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side curtain airbag(s) [AIRBAG,ROOF]
• Seat belt tensioner(s)
• Side impact sensor(s) (first) [AIRBAG SENSOR,SIDE]
• Side impact sensor(s)(second) [AIRBAG SENSOR,QTR PANEL]
• Roll rate sensor [AIRBAG SENSOR,INTERIOR]
• Roof trim
• Headliner
• A-pillar trim and related trim clips
• B-pillar Lower trim
• C-pillar trim and related trim clips
• Front grab handle
• Rear grab handle
• All related trim clips
• Sunvisor
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace the components as needed• Do not replace the ODS unit unless it is physically damaged or a specific DTC was found during troubleshooting
• After a vehicle collision, do the ODS unit operation check.
• After a vehicle collision, inspect the front seat active head restraints
• Inspect all the SRS wire harnesses. Replace, do not repair, any damaged harnesses.
• Inspect the cable reel for heat damage. If there is any damage, replace the cable reel. [CLOCK SPRING]
• Seat belt assemblies
• Seats
• Front passenger's weight sensors
• Any restraint system part or wiring identified by diagnostic check
| Additional Information |