OEM Restraints System Part Replacement Search
2011 Hyundai Santa Fe
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Turn the ignition switch OFF2. Disconnect the negative
cable from the battery
3. Wait at least 3 minutes before beginning work
Before removing any of the SRS parts (including the disconnection of the connectors), always disconnect the
SRS connector.
REV: 11/2011
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
When the front airbag(s) deployed after a collision, replace the following items:• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL]
• Seat belt pretensioner(s)
• Front impact sensors [AIRBAG SENSOR,FRT BMPR]
• SRS wiring harnesses
When the seat belt/seat belt buckle pretensioner(s) deployed after a collision, replace the following items:
• Seat belt pretensioner(s)
• SRSCM (if B1658 detected) [MODULE,AIRBAG CONTROL]
• Front impact sensors [AIRBAG SENSOR,FRT BMPR]
• SRS wiring harnesses
When the side/curtain airbag(s) deployed after a collision, replace the following items:
• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG & SEAT BACK ASSY; AIRBAG,ROOF]
• Side impact sensor(s) for the deployed side(s) [AIRBAG SENSOR,SIDE; AIRBAG SENSOR,QTR PANEL]
• SRS wiring harnesses
• The side airbag cannot be disassembled from the seat back assembly, so replace assembly when replacing the side airbag.
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• Before doing any SRS repairs, use the GDS Pro to check for DTCs. Refer to the Diagnostic Trouble Code list forrepairing of the related DTCs.
• Steering wheel
• Inspect the clock spring for heat damage. If any damage found, replace the clock spring.
• If the crash pad is damaged when the PAB [AIRBAG,INSTRUMENT PNL] is deployed, replace the damaged crash pad and PAB together.
After the vehicle is completely repaired, confirm the SRS airbag system is OK:
• Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off.
| Additional Information |