OEM Restraints System Part Replacement Search

2010 Acura ZDX

Print

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

1) Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode
2) Disconnect the negative cable from the battery
3) Wait at least 3 minutes before starting work

Before disconnecting the SRS unit connectors, always disconnect the appropriate SRS parts connectors

REV: 12/2013

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

After a collision where the front seat belt tensioners deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Front seat belt(s)
• Front impact sensor(s) [AIRBAG SENSOR,FENDER]

After a collision where the front airbag(s) deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed front airbag(s) [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL]
• Front seat belt(s)
• Front impact sensor(s) [AIRBAG SENSOR,FENDER]
• Dashboard

After a collision where a side airbag deployed, replace the items for the side(s) that deployed:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side airbag(s) [AIRBAG,FRONT SEAT]
• Side impact sensor(s) (first) [AIRBAG SENSOR,SIDE]
• Side impact sensor(s) (second) [AIRBAG SENSOR,QTR PANEL]
• Rear safing sensor [AIRBAG SENSOR,FLOOR MTD]
• B-pillar lower trim
• Seat frame and related parts: After a collision where the side airbag was deployed, replace the side airbag and the seat frame with the new parts. If the seat-back cover is split, it must be replaced [AIRBAG,FRONT SEAT]
• Front seat belt(s)

After a collision where a side curtain airbag has deployed, replace the items for the side(s) that deployed:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side curtain airbag(s) [AIRBAG,ROOF]
• Front seat belt(s)
• Side impact sensor(s) (first) [AIRBAG SENSOR,SIDE]
• Side impact sensor(s) (second) [AIRBAG SENSOR,QTR PANEL]
• Rear safing sensor [AIRBAG SENSOR,FLOOR MTD]
• A-pillar trim
• B-pillar upper trim
• Quarter pillar trim
• Front grab handle
• Rear grab handle
• All related trim clips
• Sunvisor

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

• If there is a breaking or damage found in harness relevant to the replacement parts, replace it, do not repair.
• Before doing any SRS repairs, Check for DTCs with the HDS, for the less obvious deployed parts (front seat belt tensioners, front impact sensors, side impact sensors, rear safing sensor, etc.).
• Do not replace the ODS unit unless it is physically damaged or a specific fault was found during DTC troubleshooting
• After a vehicle collision, do the ODS unit operation check
• After a vehicle collision, inspect the front seat active head restraints
• After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace the components as needed
• Check the front passenger's weight sensor output after a vehicle collision

During the repair process, inspect these areas:
• Inspect all the SRS wire harnesses. Replace, do not repair, any damaged harnesses.
• Inspect the cable reel for heat damage. If there is any damage, replace the cable reel [CLOCK SPRING]
• Replace all damaged parts
Additional Information