PrintDISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Turn ignition switch to OFF and remove key.2. Disconnect and isolate negative battery cable.
3. Wait at least 90 seconds.
REV: 11/2013
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
When any of the airbags have deployed due to the collision, be sure to replace all sensors in the damaged areas and center airbag sensor assembly.• Steering Pad, [AIRBAG,STEERING WHEEL], [if deployed]
• Front Passenger Airbag Assembly [AIRBAG,INSTRUMENT PNL], [if deployed]
• Front seat side airbag assembly [AIRBAG & SEAT ASSY,FRT], [if deployed]
• Curtain shield airbag assembly [AIRBAG,ROOF], [if deployed]
• When airbags have deployed as the result of a collision, be certain to replace all airbag sensors in the damaged area (anywhere in need of repair) [AIRBAG SENSOR,FRONT; AIRBAG SENSOR,INTERIOR; AIRBAG SENSOR,INTERIOR]
• Center airbag sensor assembly [MODULE,AIRBAG CONTROL]
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
Perform a diagnostic system check• Steering Pad, [AIRBAG,STEERING WHEEL]
• Front Passenger Airbag Assembly [AIRBAG,INSTRUMENT PNL]
• Front Seat Side Airbag Assembly [AIRBAG & SEAT ASSY,FRT]
• Curtain Shield Airbag Assembly [AIRBAG,ROOF]
• Center airbag sensor assembly [MODULE,AIRBAG CONTROL]
• Front Airbag Sensor [AIRBAG SENSOR,FRONT]
• Side Airbag Sensor [AIRBAG SENSOR,INTERIOR]
• Rear Airbag Sensor [AIRBAG SENSOR,INTERIOR]
• Seat Position Airbag Sensor
• Front Seat Inner Belt Assembly
• Front Seat Outer Belt Assembly
• Occupant Classification ECU
• Steering wheel
• Instrument panel or Instrument panel reinforcement
• Front pillar garnish and Headliner
• Perform the zero point calibration and sensitivity check Occupant Classification ECU
• Wire harnesses and connectors
• Replace the faulty parts of the seat belt systems (outer belt, inner belt, bolts, nuts, adjustable shoulder anchor, tether anchor hardware and other related parts). When inspecting a vehicle that was in a collision, be sure to check all of the seat belt systems regardless of whether or not the system was activated in the collision. Replace any damaged or malfunctioning systems
• It is also necessary to replace any airbag sensor in undamaged areas that have registered a major collision
• If any of these parts have been dropped, or a defect is found (e.g. cracks, dents or any other defects) in any of the housings, brackets or connectors, then replace the part with a new one