OEM Restraints System Part Replacement Search

2009 Jeep Grand Cherokee

Print

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

1. Disconnect and isolate the battery negative (ground) cable.
2. Wait two minutes for the system capacitor to discharge before further system service.

REV : 08/2011

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

Any vehicle which is to be returned to use following a Supplemental Restraint System (SRS) component deployment must have the deployed restraints replaced

When Driver Airbag has deployed:
• Driver Airbag [AIRBAG,STEERING WHEEL]
• Clockspring
• Steering Column Assembly including Intermediate Shaft/Coupler
• Seat belt tensioners
• All Seat Belt Retractors and Buckles in use

When Passenger Airbag has
deployed:
• Passenger Airbag [AIRBAG,INSTRUMENT PNL]
• Instrument panel top pad
• Seat belt tensioners
• Passenger Airbag wiring harness or connector if available (Must use approved wire crimping tool and splices)

When Side Curtain Airbag has deployed:
• Side Curtain Airbag [AIRBAG,ROOF]
• Headliner
• A, B, C and D-pillar trim on the same side of the vehicle as the deployed airbag
• All Seat Belt Retractors and Buckles in use

The seat belt tensioners can be deployed independent of an airbag deployment, but must also be replaced if either front airbag has been deployed

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

It is critical that the mounting surfaces and mounting brackets for the Occupant Restraint Controller (ORC), front impact sensors and side impact sensors be closely inspected and restored to their original conditions following any vehicle impact damage. [AIRBAG MODULE,INTERIOR; AIRBAG SENSOR,FRONT; AIRBAG SENSOR,SIDE]

• Lower anchors and tether for children (LATCH)
• Inspect all trim panels
• All seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage

When Driver Airbag has deployed:
• Steering Wheel

When Side Curtain Airbag has deployed:
• Sunroof
• Sunroof Drain Tubes and Hoses
• Seat Belt Tensioners

• All other vehicle components should be closely inspected following any SRS component deployment, but are to be replaced only as required by the extent of the visible damage incurred

There are two methods by which an airbag or seat belt tensioner may be connected to the vehicle electrical system.
1) The first method involves a short pigtail harness and connector insulator that are integral to the airbag or tensioner unit and are replaced as a unit with the service replacement airbag or seat belt tensioner unit.
2) The second method involves a wire harness takeout and connector insulator (squib circuits) that are connected directly to the air bag or tensioner initiator. The heat created by the initiator during an airbag or tensioner deployment will cause collateral damage to a directly connected wire harness take out and connector insulator. Therefore, these direct-connect type take outs and connector insulators must be repaired following an airbag or seat belt tensioner deployment
• Any restraint system part or wiring identified by diagnostic check
Additional Information