OEM Restraints System Part Replacement Search

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

1. Turn ignition switch to LOCK and remove key.
2. Remove battery cover.
3. Disconnect battery ground cable.
4. Wait at least 1 minute.

•••Radio code saving devices must not be used when conducting work on airbags.

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

For a front airbag deployment:
• Deployed airbag modules
• Front and rear safety belt assemblies that were in use during deployment
• RCM module after 5 separate deployments
• Any damaged or defective restraint system part

For a side airbag deployment:
• Complete seat assembly
• Front and rear safety belt assemblies that were in use during deployment
• RCM module after 5 separate deployments
• Any damaged or defective restraint system part

For a curtain airbag deployment:
• Curtain airbag module
• Headliner
• A, B, and C pillar trim panels
• Any damaged or defective restraint system part

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

For a front airbag deployment:
• Airbag sliding contact [Clockspring]
• Safety belt assemblies not in use during deployment
• Safety belt buckles
• Safety belt buckle support assemblies
• All airbag sensors
• All sensor brackets
• Sensor wiring pigtail
• Any restraint system part or wiring identified by the restraint diagnostic checks

For a side airbag deployment:
• Safety belt assemblies not in use during deployment
• Safety belt buckles
• Safety belt buckle support assemblies
• All airbag sensors
• All sensor brackets
• Any restraint system part or wiring identified by the restraint diagnostic checks

For a curtain airbag deployment:
• Safety belt assemblies not in use during deployment
• Safety belt buckles
• Safety belt buckle support assemblies
• All airbag sensors
• All sensor brackets
• Any restraint system part or wiring identified by the restraint diagnostic checks