OEM Restraints System Part Replacement Search

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

1. Turn ignition switch to OFF
2. Disconnect the negative cable from the battery
3. Wait at least 3 minutes before beginning work

Before removing any of the SRS parts (including the disconnection of the connectors), always disconnect the SRS connector.

REV: 06/2012

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

When the front airbag(s) deployed after a collision, replace the following items:
• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL]
• Deployed seat belt pretensioner(s)
• Front impact sensors [AIRBAG SENSOR,FRONT]
• SRS wiring harnesses
• Replace the crash pad which is damaged while PAB is deployed

When the seat belt pretensioner(s) deployed after a collision, replace the following items:
• Deployed seat belt pretensioner(s)
• SRSCM [MODULE,AIRBAG CONTROL]
• Front impact sensors [AIRBAG SENSOR,FRONT]
• SRS wiring harnesses

When the side/curtain airbag(s) deployed after a collision, replace the following items:
• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG & SEAT BACK ASSY]
• Side impact sensor(s) for the deployed side(s) [AIRBAG SENSOR,INTERIOR]
• SRS wiring harnesses

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

• Before doing any SRS repairs, use the Hi-Scan Pro to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs
• Inspect the clock spring for heat damage. If any damage found, replace the clock spring
• Steering wheel