OEM Restraints System Part Replacement Search
2007 Toyota Prius (Hybrid)
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
Before using an electric welder anywhere on the vehicle, disconnect the center airbag sensor assembly connectors. These connectors contain shorting springs. This feature reduces the possibility of the airbag deploying due to current entering the squib wiring.1. Turn ignition switch to OFF and remove key.
2. Disconnect and isolate negative battery cable.
3. Wait at least 90 seconds.
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
With a front airbag deployment:• Steering wheel pad/horn button assembly (includes airbag)
• Front passenger airbag assembly
• Front airbag sensors (LT/RT)
• Center airbag sensor assembly [Module, Airbag Control]
• All seat belt pretensioners
• Any damaged restraint system part
With a front seat airbag deployment:
• Front seat airbag assembly (LT/RT)
• Center airbag sensor assembly [Module, Airbag Control]
• Side airbag sensors (LT/RT)
• Rear airbag sensor (LT/RT)
• Any damaged restraint system part
With a curtain shield airbag deployment:
• Curtain shield airbag assembly (LT/RT)
• Center airbag sensor assembly [Module, Airbag Control]
• Side rear airbag sensors
• Rear airbag sensor (LT/RT)
• Any damaged restraint system part
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
With a front airbag deployment:• Spiral cable
• Steering wheel
• Instrument panel
• Instrument panel reinforcement
• Occupant Classification ECU
• Seat position sensor
• SRS wire harnesses or connectors
• Any restraint system part or wiring identified by diagnostic check
With a side airbag deployment:
• Seatback installation part of the seat adjuster
• SRS wire harnesses or connectors
• Any restraint system part or wiring identified by diagnostic check
With a curtain shield airbag deployment:
• Surrounding headliner and inner trim
• SRS wire harnesses or connectors
• Any restraint system part or wiring identified by diagnostic check
| Additional Information |