OEM Restraints System Part Replacement Search
2007 Jaguar X-Type
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Turn ignition switch to LOCK and remove key.2. Remove battery cover.
3. Disconnect battery ground cable.
4. Wait at least 1 minute.
•••Radio code saving devices must not be used when conducting work on airbags.
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
For a front airbag deployment:• Deployed airbag modules
• Safety belt assemblies that were in use during deployment
• Passenger Airbag Deactivation (PAD) indicator
• RCM module after 5 separate deployments
• Any damaged or defective restraint system part
For a side airbag deployment:
• Complete seat assembly
• Safety belt assemblies that were in use during deployment
• RCM module after 5 separate deployments
• Any damaged or defective restraint system part
For a curtain airbag deployment:
• Curtain airbag module [Roof airbag]
• Headliner
• A, B, and C pillar trim panels
• Any damaged or defective restraint system part
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
For a front airbag deployment:• Airbag sliding contact [Clockspring]
• Safety belt assemblies not in use during deployment
• Safety belt buckles
• Safety belt buckle support assemblies
• All sensor brackets
• Airbag sensors
• Sensor wiring pigtail
• Any restraint system part or wiring identified by the restraint diagnostic checks
For a side airbag deployment:
• Safety belt assemblies not in use during deployment
• Safety belt buckles
• Safety belt buckle support assemblies
• Airbag sensors
• All sensor brackets
• Any restraint system part or wiring identified by the restraint diagnostic checks
For a curtain airbag deployment:
• Safety belt assemblies not in use during deployment
• Safety belt buckles
• Safety belt buckle support assemblies
• Airbag sensors
• All sensor brackets
• Any restraint system part or wiring identified by the restraint diagnostic checks
| Additional Information |