PrintDISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Turn ignition switch to OFF and remove key.2. Disconnect and isolate negative battery cable.
3. Wait at least 90 seconds.
NOTICE:
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
REV: 05/2025
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
When any of the airbags have deployed due to the collision, be sure to replace all sensors in the damaged areas and center airbag sensor assembly [AIRBAG SENSOR,FRONT; AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,QTR PANEL; AIRBAG SENSOR,FLOOR; MODULE, AIRBAG CONTROL]• Deployed Steering wheel pad [AIRBAG, STEERING WHEEL]
• Deployed Front passenger airbag assembly [AIRBAG,INSTRUMENT PNL]
• Deployed Driver side knee airbag assembly, [AIRBAG,KNEE BOLSTER]
• Deployed Front passenger side knee airbag assembly, [AIRBAG,KNEE BOLSTER]
• Deployed Curtain shield airbag assembly, [AIRBAG,ROOF]
• Deployed Side seat airbag [AIRBAG,FRONT SEAT; AIRBAG & SEAT ASSY,MIDDLE]
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• Steering pad [AIRBAG, STEERING WHEEL]• Front passenger airbag
• Curtain shield airbag [AIRBAG,ROOF]
• Front seat airbag [AIRBAG,FRONT SEAT]
• Driver side knee airbag [AIRBAG,KNEE BOLSTER]
• Front passenger side knee airbag [AIRBAG,KNEE BOLSTER]
• Rear seat side airbag [AIRBAG & SEAT ASSY,MIDDLE]
• Rear floor airbag sensor [AIRBAG SENSOR,FLOOR]
• Seat belt pretensioner
• Center airbag sensor [MODULE, AIRBAG CONTROL]
• Front airbag sensor [AIRBAG SENSOR,FRONT]
• Side airbag sensor [AIRBAG SENSOR,FRT DOOR]
• Rear airbag sensor [AIRBAG SENSOR,QTR PANEL]
• Occupant classification ECU
• Perform initialization of the occupant classification ECU
• Seat position sensor [AIRBAG SENSOR,SEAT TRACK]
• Replace the faulty parts of the seat belt systems (outer belt, inner belt, bolts, nuts, adjustable shoulder anchor, tether anchor hardware and other related parts). When inspecting a vehicle that was in a collision, be sure to check all of the seat belt systems regardless of whether or not the system was activated in the collision. Replace any damaged or malfunctioning systems