OEM Restraints System Part Replacement Search
2024 Hyundai Elantra Sedan Hybrid
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
Except when performing electrical inspections:1) Always turn the ignition switch OFF
2) Disconnect the negative cable from the battery
3) Wait at least three minutes before beginning work
Before removing any of the SRSCM parts (including the disconnection of the connectors), always disconnect the SRSCM connector.
REV: 03/2025
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
When the front airbag(s) deployed after a collision, replace the following items:• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL]
• Seat belt pretensioner(s)
• Emergency fastening device(s)
• Front impact sensor [AIRBAG SENSOR,FRONT]
• SRS wiring harnesses
• Replace the crash pad which that has been damaged after the PAB has been deployed
When the side/curtain airbag(s) deployed after a collision, replace the following items:
• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG & SEAT BACK ASSY; AIRBAG,ROOF]
• Side impact sensor(s) for the deployed side(s) [AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,SIDE]
• SRS wiring harnesses
• Seat belt pretensioner(s)
• Emergency fastening device(s)
NOTE: The side airbag cannot be disassembled from the seat back assembly, so replace assembly when replacing the side airbag
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
When the front airbag(s) deployed after a collision:• Inspect the clock spring for heat damage. If any damage found, replace the clock spring.
• Steering wheel
After the vehicle is completely repaired, confirm the SRS airbag system is OK.
| Additional Information |