OEM Restraints System Part Replacement Search

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

1. Turn the ignition switch OFF
2. Disconnect the negative cable from the battery
3. Wait at least 3 minutes before beginning work

Before removing any of the SRS parts (including the disconnection of the connectors), always disconnect the SRS connector.

REV: 01/2025

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

When the front airbag(s) deployed after a collision, replace the following items:
• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG,STEERING WHEEL; AIRBAG,KNEE BOLSTER; AIRBAG,INSTRUMENT PNL]
• Seat belt pretensioner(s)
• Front impact sensors [AIRBAG SENSOR,FRONT]
• SRS wiring harnesses
• Replace the crash pad which is damaged when the PAB [AIRBAG,INSTRUMENT PNL] is deployed

When the side/curtain airbag(s) deployed after a collision, replace the following items:
• SRSCM [MODULE,AIRBAG CONTROL]
• Seat belt pretensioner(s)
• Deployed airbag(s) [AIRBAG & SEAT BACK ASSY; AIRBAG,ROOF]
• Side impact sensor(s) for the deployed side(s) [AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,QTR PANEL]
• SRS wiring harnesses

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

• Before doing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs.
• Steering wheel
• Inspect the clock spring for heat damage. If any damage found, replace the clock spring.

After the vehicle is completely repaired, confirm the SRS airbag system is OK:
• Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off.