OEM Calibration Requirements Search
2023 RAM 1500 (DS)
Click the links below for directions; definitions; articles; and additional RTS portal information such as OEM position statements and publications.
Camera in Deck Lid/Liftgate/Tailgate
OEM Name: Rear Camera
Calibration/Initialization Requirement Events:
- No calibration/initialization requirements found
| Camera in Deck Lid/Liftgate/Tailgate | Yes | No | Not Identified |
| DTC Set | X | ||
| Scan Tool Required | X | ||
| Special Tools Required | X |
Camera Near Rearview Mirror
OEM Name: Drivers Assistance System Module
Calibration/Initialization Requirement Events:
- If drivers assistance system module is removed/installed or replaced
- If DTC indicates
- If tire diameter changes
- If windshield is removed/installed or replaced
| Camera Near Rearview Mirror | Yes | No | Not Identified |
| DTC Set | X | ||
| Scan Tool Required | X | ||
| Special Tools Required | X |
Note:
Per RAM service information: "The interior windshield mounted Drivers Assistance System Module (DASM) (1) includes a camera sensor component and a radar sensor component both housed within a common single module housing"
Camera on Rearview Mirror
OEM Name: Smart Beam
Calibration/Initialization Requirement Events:
- No calibration/initialization requirements found
| Camera on Rearview Mirror | Yes | No | Not Identified |
| DTC Set | X | ||
| Scan Tool Required | X | ||
| Special Tools Required | X |
Note:
Per RAM service information: "New and unused replacement SmartBeam® units are shipped calibrated from the factory. Replace the mirror assembly if a loss of calibration is experienced."
Sensor(s) in Front Bumper Cover/Grille
OEM Name: Park Assist Sensor
Calibration/Initialization Requirement Events:
- No calibration/initialization requirements found
| Sensor(s) in Front Bumper Cover/Grille | Yes | No | Not Identified |
| DTC Set | X | ||
| Scan Tool Required | X | ||
| Special Tools Required | X |
Sensor(s) in Rear Bumper Cover
OEM Name: Park Assist Sensor
Calibration/Initialization Requirement Events:
- No calibration/initialization requirements found
| Sensor(s) in Rear Bumper Cover | Yes | No | Not Identified |
| DTC Set | X | ||
| Scan Tool Required | X | ||
| Special Tools Required | X |
Sensor(s) Near Rearview Mirror
OEM Name: Drivers Assistance System Module
Calibration/Initialization Requirement Events:
- If drivers assistance system module is removed/installed or replaced
- If DTC indicates
- If tire diameter changes
- If windshield is removed/installed or replaced
| Sensor(s) Near Rearview Mirror | Yes | No | Not Identified |
| DTC Set | X | ||
| Scan Tool Required | X | ||
| Special Tools Required | X |
Note:
Per RAM service information: "The interior windshield mounted Drivers Assistance System Module (DASM) (1) includes a camera sensor component and a radar sensor component both housed within a common single module housing"
| Additional Information | |