OEM Calibration Requirements Search
2022 Honda Civic
Click the links below for directions; definitions; articles; and additional RTS portal information such as OEM position statements and publications.
Camera in Deck Lid/Liftgate/Tailgate
OEM Name: Rearview Camera
Calibration/Initialization Requirement Events:
- No calibration/initialization requirements found
| Camera in Deck Lid/Liftgate/Tailgate | Yes | No | Not Identified |
| DTC Set | X | ||
| Scan Tool Required | X | ||
| Special Tools Required | X |
Camera in Side Mirror (Right)
OEM Name: LaneWatch Camera
Calibration/Initialization Requirement Events:
- If front passenger door is adjusted
- If front passenger door is removed/installed or replaced
- If LaneWatch camera unit is removed/installed or replaced
- If passenger door assembly has any repairs made to it
- If passenger side power mirror assembly is removed/installed or replaced
| Camera in Side Mirror (Right) | Yes | No | Not Identified |
| DTC Set | X | ||
| Scan Tool Required | X | ||
| Special Tools Required | X |
Camera Near Rearview Mirror
OEM Name: Multipurpose Camera Unit
Calibration/Initialization Requirement Events:
- If camera is removed/installed or replaced
- If DTC indicates
- If structural repairs are made
- If supplemental restraint system (SRS) is deployed
- If windshield is removed/installed or replaced
| Camera Near Rearview Mirror | Yes | No | Not Identified |
| DTC Set | X | ||
| Scan Tool Required | X | ||
| Special Tools Required | X |
Sensor(s) in Front Bumper Cover/Grille
OEM Name: Parking and Back-Up Sensor
Calibration/Initialization Requirement Events:
- If sensor is replaced
- If sensor mounting location is changed
| Sensor(s) in Front Bumper Cover/Grille | Yes | No | Not Identified |
| DTC Set | X | ||
| Scan Tool Required | X | ||
| Special Tools Required | X |
Note:
Per the Honda Service Information manual, initialization only required if vehicle is equipped with "Parking and Back-Up Sensor System (with Low Speed Brake Control)"
Sensor(s) in Quarter Panel Behind Bumper Cover (Sides)
OEM Name: BSI Radar Unit
Calibration/Initialization Requirement Events:
- If body panel repairs are made near the BSI mounting location
- If BSI radar unit is removed/installed or replaced
- If DTC indicates
- If rear end structural repairs are made
| Sensor(s) in Quarter Panel Behind Bumper Cover (Sides) | Yes | No | Not Identified |
| DTC Set | X | ||
| Scan Tool Required | X | ||
| Special Tools Required | X |
Note:
Per the Honda Service Information manual, an operation check is required (BSI Radar Unit Aiming Inspection). Special tools required are for the operation check.
Sensor(s) in Rear Bumper Cover
OEM Name: Parking and Back-Up Sensor
Calibration/Initialization Requirement Events:
- If sensor is replaced
- If sensor mounting location is changed
| Sensor(s) in Rear Bumper Cover | Yes | No | Not Identified |
| DTC Set | X | ||
| Scan Tool Required | X | ||
| Special Tools Required | X |
Note:
Per the Honda Service Information manual, initialization only required if vehicle is equipped with "Parking and Back-Up Sensor System (with Low Speed Brake Control)"
| Additional Information | |