OEM Partial Part Replacement Search
2020 Chevrolet Trax
Click the links below for the OEM repair information website (note: additional purchase may be required for a subscription to each OEM); How To Use The OEM Partial Part Replacement Search; I-CAR Best Practice: Disassembly of a Steel Service Part at a Factory Seam; and additional RTS portal information such as Collision Repair News articles, OEM position statements, publications, and additional resources.
Front
Front Lower Rail |
|
Sectioning:
Single OEM Location |
|
Partial Part At Factory Seam:
No OEM Procedure |
Front Upper Rail |
|
Sectioning:
No OEM Procedure |
|
Partial Part At Factory Seam:
OEM Procedure(s) Available |
Side
Outer Uniside |
|
Sectioning:
OEM Procedure(s) Available |
|
Note: Does NOT have outer quarter panel w/rolled hem flange |
Uniside Reinforcement |
|
Sectioning:
OEM Warning, Do Not Section |
Inner Uniside |
|
Sectioning:
No OEM Procedure |
Per the 2020 Chevrolet Trax body repair manual:
"Note: The rocker inner panel is made of Ultra High Strength Dual Phase Steel and should be replaced only at factory joints. Repairing or sectioning of this part is not recommended. "
"Note: The center pillar upper stiffener is made of Dual Phase Steel and should be replaced only at factory joints. Repairing or sectioning of this part is not recommended."
Rear
Rear Rail |
|
Sectioning:
Single OEM Location |
|
Partial Part At Factory Seam:
No OEM Procedure |
Trunk Floor |
|
Sectioning:
No OEM Procedure |
|
Partial Part At Factory Seam:
Single OEM Location |
Rear Body Panel |
|
Sectioning:
No OEM Procedure |
| Additional Information | |