OEM Calibration Requirements Search
2019 Ford Mustang
Click the links below for directions; definitions; articles; and additional RTS portal information such as OEM position statements and publications.
Camera in Deck Lid/Liftgate/Tailgate
OEM Name: Rear Parking Aid Camera
Calibration/Initialization Requirement Events:
- If camera is replaced
| Camera in Deck Lid/Liftgate/Tailgate | Yes | No | Not Identified |
| DTC Set | X | ||
| Scan Tool Required | X | ||
| Special Tools Required | X |
Camera Near Rearview Mirror
OEM Name: Lane Keeping Camera
Calibration/Initialization Requirement Events:
- If front air bag is deployed
- If interior mirror is replaced
- If there is a change in the tire size
- If there is suspension repair, alignment, or modification
- If windshield is replaced
| Camera Near Rearview Mirror | Yes | No | Not Identified |
| DTC Set | X | ||
| Scan Tool Required | X | ||
| Special Tools Required | X |
Note:
If replacing the camera with a new one, data will typically need to be transferred from existing camera.
Sensor(s) Behind Front Bumper Cover/Grille
OEM Name: Cruise Control Module (CCM)
Calibration/Initialization Requirement Events:
- If sensor is removed/installed or replaced
| Sensor(s) Behind Front Bumper Cover/Grille | Yes | No | Not Identified |
| DTC Set | X | ||
| Scan Tool Required | X | ||
| Special Tools Required | X |
Note:
If replacing the sensor with a new one, data will typically need to be transferred from existing sensor.
Sensor(s) Behind Rear Bumper Cover
OEM Name: Side Obstacle Detection Control Module
Calibration/Initialization Requirement Events:
- No calibration/initialization requirements found
| Sensor(s) Behind Rear Bumper Cover | Yes | No | Not Identified |
| DTC Set | X | ||
| Scan Tool Required | X | ||
| Special Tools Required | X |
Note:
If replacing the sensor with a new one, data will typically need to be transferred from existing sensor.
Sensor(s) in Rear Bumper Cover
OEM Name: Rear Parking Aid Sensor
Calibration/Initialization Requirement Events:
- No calibration/initialization requirements found
| Sensor(s) in Rear Bumper Cover | Yes | No | Not Identified |
| DTC Set | X | ||
| Scan Tool Required | X | ||
| Special Tools Required | X |
Note:
Per the Ford Workshop manual, operation checks are required. (Azimuth System Check, Elevation System Check)
| Additional Information | |