OEM Restraints System Part Replacement Search
2014 INFINITI G37/Q60 Convertible
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
WARNING:To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance should be performed by an authorized NISSAN/INFINITI dealer.
1. Turn the ignition switch OFF.
2. Disconnect both battery cables.
3. Wait at least 3 minutes.
REV: 12/2014
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
FOR FRONTAL COLLISION:• If the driver air bag has deployed: REPLACE Install with new fasteners. [AIRBAG,STEERING WHEEL]
• If the front passenger air bag has deployed: REPLACE Install with new fasteners. [AIRBAG,INSTRUMENT PNL]
• If any of the front air bags or seat belt pre-tensioners have been activated: REPLACE the crash zone sensor and bracket with new fasteners. [AIRBAG SENSOR,FRONT]
• Seat belt pre-tensioner assemblies (All applicable locations: buckle, retractor, lap outer) REPLACE all seat belt pre-tensioner assemblies with new fasteners. •: Confirm seat belt pre-tensioner activation using CONSULT only.
• If any of the SRS components have been activated: REPLACE the diagnosis sensor unit. Install with new fasteners [MODULE,AIRBAG CONTROL]
• If the driver front air bag has deployed: REPLACE the spiral cable. [CLOCK SPRING]
• If the passenger air bag has deployed: REPLACE the instrument panel assembly. (integrated type)
• Always replace instrument panel pad following front passenger air bag deployment
FOR SIDE AND ROLLOVER COLLISION:
• If the side air bag LH has deployed: REPLACE front seatback assembly LH. [AIRBAG,FRONT SEAT]
• If the side air bag RH has deployed: REPLACE front seatback assembly RH. [AIRBAG,FRONT SEAT]
• If the door-mounted curtain air bag module LH has deployed: REPLACE the door finisher LH and door-mounted curtain air bag module. Install with new fasteners. [AIRBAG,FRONT DOOR]
• If the door-mounted curtain air bag module RH has deployed: REPLACE the door finisher RH and door-mounted curtain air bag module. Install with new fasteners. [AIRBAG,FRONT DOOR]
• If any of the SRS components have deployed: REPLACE the satellite sensor on the collision side with new fasteners. [AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,QTR PANEL (if equipped)]
• If the pop-up roll bar has deployed: REPLACE pop-up roll bar assemblies and pop-up roll bar covers. Install with new fasteners [ROLL BAR ASSEMBLY]
• If any of the SRS components have deployed: REPLACE the diagnosis sensor unit with new fasteners. [MODULE,AIRBAG CONTROL]
• Seat belt pre-tensioner assemblies (All applicable locations: buckle, retractor, lap outer) REPLACE all seat belt pre-tensioner assemblies with new fasteners. •: Confirm seat belt pre-tensioner activation using CONSULT only.
Replace any seat belt assembly (including anchor bolts) if:
• The seat belt was in use at the time of a collision (except for minor collisions and the belts, retractors and buckles show no damage and continue to operate properly).
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
Replace any SRS components and the related parts showing visible signs of damage. (dents, cracks, deformation, etc.)• Steering wheel
• Airbag Modules that have not deployed
• Steering wheel harness, connectors and terminals
• Wiring harness, connectors and terminals
• Occupant Classification System
• Seats and seat mounting points
• Instrument panel assembly
• Pop-up roll bar
• Inspect all seat belt assemblies including retractors and attaching hardware and mounting points after any collision
• Check for deformities of the center pillar inner
• Replace any seat belt assembly (including anchor bolts) if Seat belt attaching point was damaged in an accident.
• Doors and Door trim
WARNING:
Inspect all seat belt assemblies including retractors and attached hardware after any collision. NISSAN recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly. Failure to do so could result in serious personal injury in an accident. Seat belt assemblies not in use during a collision should also be replaced if either damage or improper operation is noted.
Replace any seat belt assembly (including anchor bolts) if:
• The seat belt was in use at the time of a collision (except for minor collisions and the belts, retractors and buckles show no damage and continue to operate properly).
• The seat belt was damaged in an accident (i.e. torn webbing, bent retractor or guide).
• The seat belt attaching point was damaged in an accident. Inspect the seat belt attaching area for damage or distortion and repair as necessary before installing a new seat belt assembly.
• Anchor bolts are deformed or worn out.
• The front seat belt pre-tensioner should be replaced even if the seat belts are not in use during the collision in which the air bags are deployed.