2007 INFINITI G35/G37/Q40 Sedan

OEM Restraints System Part Replacement Search

2007 INFINITI G35/G37/Q40 Sedan

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

WARNING:
To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance should be performed by an authorized NISSAN/INFINITI dealer.

1. Turn the ignition switch OFF.
2. Disconnect both battery cables
3. Wait at least 3 minutes.

REV: 02/2015

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

FOR FRONTAL COLLISION When SRS is activated in a collision:
• If the driver air bag has deployed: REPLACE Install with new fasteners. [AIRBAG,STEERING WHEEL]
• If the front passenger air bag has deployed: REPLACE Install with new fasteners. [AIRBAG,INSTRUMENT PNL]
• If any of the front air bags or seat belt pre-tensioners have been activated: REPLACE the crash zone sensor and bracket with new fasteners. [AIRBAG SENSOR,FRONT]
• Seat belt pre-tensioner assemblies (All applicable locations: buckle, retractor, lap outer), if deployed
• If any of the SRS components have been activated: REPLACE the diagnosis sensor unit. Install with new fasteners [MODULE,AIRBAG CONTROL]
• If the driver front air bag has deployed: REPLACE the spiral cable [CLOCK SPRING]
• If the front passenger air bag has deployed: REPLACE the instrument panel assembly. (integrated type)
• Always replace instrument panel pad following front passenger air bag deployment

FOR SIDE AND ROLLOVER COLLISION When SRS is activated in a collision:
• If the side curtain air bag LH has deployed: REPLACE the side curtain air bag module LH. [AIRBAG,ROOF]
• If the side curtain air bag RH has deployed: REPLACE the side curtain air bag module RH. [AIRBAG,ROOF]
• If the front side air bag LH has deployed: REPLACE front seatback assembly LH. [AIRBAG,FRONT SEAT and seat components]
• If the front side air bag RH has deployed: REPLACE front seatback assembly RH. [AIRBAG,FRONT SEAT and seat components]
• If any of the SRS components have deployed: REPLACE the side air bag (satellite) sensor on the collision side with new fasteners [AIRBAG SENSOR,SIDE]
• If any of the SRS components have deployed: REPLACE the diagnosis sensor unit with new fasteners. [MODULE,AIRBAG CONTROL]
• Seat belt pre-tensioner assemblies (All applicable locations: buckle, retractor, lap outer), if deployed

NISSAN recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly.

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

For a front airbag deployment:
• Airbag modules that have not deployed
• Steering wheel and Steering wheel harness, connectors and terminals
• Seat belt pre-tensioner assemblies (All applicable locations: buckle, retractor, lap outer)
• Check the center inner pillar on the collision side for damage (dents, cracks, deformation, etc.)
• If the center pillar inner has been damaged, REPLACE the seat belt pre-tensioner assembly
• Occupant classification system (Passenger seat)
• Wiring harness, connectors and terminals. If damaged • REPLACE the damaged harness. Do not attempt to repair, splice or modify any SRS harness.
• Instrument panel (if damaged, replace with new bolts)
• Seatbelts and seatbelt mounting points
• Seats and seat mounting points.
• Replace any SRS components showing visible signs of damage. (dents, cracks and deformation, etc.)
• Do not attempt to repair, splice or modify any SRS harness.
• NISSAN recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly.

For a side airbag deployment:
• Airbag modules that have not deployed
• Seats and seat mounting points.
• Check the center inner pillar on the collision side for damage (dents, cracks, deformation, etc.)
• Seatbelts and seatbelt mounting points
• Occupant classification system (Passenger seat)
• Trim/headliner
• Replace any SRS components showing visible signs of damage. (dents, cracks and deformation, etc.)
• If the center pillar inner has been damaged, REPLACE the seat belt pre-tensioner assembly
• Do not attempt to repair, splice or modify any SRS harness.
• NISSAN recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly.