OEM Restraints System Part Replacement Search

---

2007 Porsche Boxster

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

Read out the fault memory

1. Remove ignition key.
2. Disconnect and cover the negative terminal of the battery.
3. Wait 1 minute and only then disconnect the plug connection.

REV: 10/2013

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

The following components must be removed and replaced after the airbag system is triggered:

Triggered Airbag unit, driver's side:
1. Contact unit. [CLOCK SPRING]
2. Airbag unit, driver's side.
3. Triggering unit after the system is triggered for the third time [MODULE, AIRBAG CONTROL]

Triggered Airbag unit, passenger's side:
1. Airbag unit, passenger's side. [AIRBAG,INSTRUMENT PNL]
2. Triggering unit after the system is triggered for the third time [MODULE, AIRBAG CONTROL]
3. Instrument panel.

Triggered Side-airbag unit, seat:
1. Side-airbag unit, seat. [AIRBAG,FRONT SEAT]
2. Seat covering, deformed seat components.
3. Sensor for the side airbag unit after the side airbag is triggered for the third time [AIRBAG SENSOR,SIDE]
4. Triggering unit after the system is triggered for the third time [MODULE, AIRBAG CONTROL]

Triggered Head airbag unit, door:
1. Head airbag unit. [AIRBAG,DRIVER DOOR; AIRBAG,FRT PASS DOOR]
2. Sensor for the side airbag unit after the side airbag is triggered for the third time [AIRBAG SENSOR,SIDE]
3. Triggering unit after the system is triggered for the third time [MODULE, AIRBAG CONTROL]

Belt tensioner:
• All triggered belt tensioner units.
• Triggering unit after the system is triggered for the third time [MODULE, AIRBAG CONTROL]

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

Using the PIWIS Tester 9718, read out the fault memory

Airbag unit, passenger's side:
• Check instrument panel bracket for deformation and replace if necessary

Head airbag unit, door:
• Check door unit carrier for deformation and replace if necessary.

Belt tensioner:
Because it is difficult to visually determine if one or more belt tensioners has been triggered, check the following points:
– Using the PIWIS Tester 9718, read out the fault memory.
– Check plug connection on the belt tensioner for damage.
– Pull out the belt strap as far as possible and check for wear.
– Perform a function test on the automatic belt device.