OEM Restraints System Part Replacement Search
2010 INFINITI G37/Q60 Convertible
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
WARNING:To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance should be performed by an authorized NISSAN/INFINITI dealer.
1. Turn the ignition switch OFF.
2. Disconnect both battery cables.
3. Wait at least 3 minutes.
REV: 03/2013
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
FOR FRONTAL COLLISION:• If the driver air bag has deployed: REPLACE Install with new fasteners. [AIRBAG,STEERING WHEEL]
• If the front passenger air bag has deployed: REPLACE Install with new fasteners. [AIRBAG,INSTRUMENT PNL]
• If any of the front air bags or seat belt pre-tensioners have been activated: REPLACE the crash zone sensor and bracket with new fasteners. [AIRBAG SENSOR,FRONT]
• Seat belt pre-tensioner assemblies (All applicable locations: buckle, retractor, lap outer) [if deployed]
• If any of the SRS components have been activated: REPLACE the diagnosis sensor unit. Install with new fasteners [MODULE,AIRBAG CONTROL]
• If the driver front air bag has deployed: REPLACE the spiral cable. [CLOCK SPRING]
• If the passenger air bag has deployed: REPLACE the instrument panel assembly. (integrated type)
• Always replace instrument panel pad following front passenger air bag deployment
FOR SIDE AND ROLLOVER COLLISION:
• If the side air bag LH has deployed: REPLACE front seatback assembly LH. [AIRBAG,FRONT SEAT]
• If the side air bag RH has deployed: REPLACE front seatback assembly RH. [AIRBAG,FRONT SEAT]
• If the door-mounted curtain air bag module LH has deployed: REPLACE the door finisher LH and door-mounted curtain air bag module. Install with new fasteners. [AIRBAG,FRONT DOOR]
• If the door-mounted curtain air bag module RH has deployed: REPLACE the door finisher RH and door-mounted curtain air bag module. Install with new fasteners. [AIRBAG,FRONT DOOR]
• If any of the SRS components have deployed: REPLACE the satellite sensor on the collision side with new fasteners. [AIRBAG SENSOR,QTR PANEL]
• If the pop-up roll bar has deployed: REPLACE pop-up roll bar assemblies and pop-up roll bar covers. Install with new fasteners [ROLL BAR ASSEMBLY]
• If any of the SRS components have deployed: REPLACE the diagnosis sensor unit with new fasteners. [MODULE,AIRBAG CONTROL]
• Seat belt pre-tensioner assemblies (All applicable locations: buckle, retractor, lap outer) [if deployed]
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
Replace any SRS components and the related parts showing visible signs of damage. (dents, cracks, deformation, etc.)• Steering wheel
• Airbag Modules that have not deployed
• Steering wheel harness, connectors and terminals
• Wiring harness, connectors and terminals
• Occupant Classification System
• Seats and seat mounting points
• Instrument panel assembly
• Pop-up roll bar
• Inspect all seat belt assemblies including retractors and attaching hardware and mounting points after any collision
• Check for deformities of the center pillar inner
• Replace any seat belt assembly (including anchor bolts) if Seat belt attaching point was damaged in an accident.
• Doors and Door trim
• NISSAN recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly