OEM Restraints System Part Replacement Search

---

2008 Saab 9-3 Sedan

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

1. Place the ignition in the LOCK position
2. Disconnect and cover the negative battery terminal
3. Wait at least 1 minute

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

WARNING:
Replace all seatbelts if it cannot be established without doubt which belts were in use when the accident occurred.

For a Front airbag deployment:

• Steering wheel, airbag and steering column assembly
• Coil spring (contact roller)
• Control module
• All seat belts with seat belt tensioners on the front seat use during a collision
• Both the rear seat belts on the outer seats. Those in use and those not in use during a collision
The seat belt for the centre seat on the rear seat, if used during the accident
• Passenger airbag, if deployed and the dashboard

• Any damaged restraint system part.

For a side airbag deployment:

• Control module
• All seat belts with seat belt tensioners on the front seat use during a collision
• Both the rear seat belts on the outer seats. Those in use and those not in use during a collision
The seat belt for the centre seat on the rear seat, if used during the accident
• Side airbag, if deployed with backrest upholstery bag

• Any damaged restraint system part


For an inflatable curtain deployment:

• Control module
• All seat belts with seat belt tensioners on the front seat use during a collision
• Both the rear seat belts on the outer seats. Those in use and those not in use during a collision
The seat belt for the centre seat on the rear seat, if used during the accident
• Inflatable curtains, if deployed
• A-, B-, C-pillar trim and headlining

• Any damaged restraint system part

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

• Knee shield
• SRS wiring harness
• Windscreen
• Front sensors, (The front sensors do not need to be replaced if there has been no mechanical damage to the sensor and if the sensor does not give a trouble code)
• Any damaged components
• Any restraint system part or wiring identified by diagnostic check

For a side airbag deployment:
• Wiring harness for the side impact sensor, side airbag and seat-belt tensioner
• Side impact sensors (The side impact sensors do not need to be replaced if there has been no mechanical damage to the sensor and if the sensor does not give a trouble code).
• Any restraint system part or wiring identified by diagnostic check

For an inflatable curtain deployment:
• Wiring harness for the side impact sensor, inflatable curtain and seat-belt tensioner
• Side impact sensors (The side impact sensors do not need to be replaced if there has been no mechanical damage to the sensor and if the sensor does not give a trouble code).
• Any restraint system part or wiring identified by diagnostic check