OEM Restraints System Part Replacement Search
2007 Suzuki Grand Vitara
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Turn steering wheel so that vehicle wheels (front tires) are pointing straight ahead.2. Disconnect negative cable at battery.
3. Turn ignition switch to "LOCK" position and remove key.
4. Remove "A/B" fuse from fuse box.
5. Remove steering column cover and disconnect yellow connector of contact coil and combination switch assembly.
6. Remove glove box from instrument panel and disconnect yellow connector of passenger air bag.
7. If equipped with side air bag (inflator) module, disconnect yellow connector of side air bag (inflator) module under front seat cushion.
8. If equipped with side curtain air bag (inflator) module, remove quarter inner trim and disconnect black connector of side curtain air bag (inflator) module.
NOTE:
With "A/B" fuse removed and ignition switch ON, "AIR BAG" warning lamp will be ON. This is normal operation and does not indicate an air bag system malfunction.
REV: 09/2013
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
When driver and passenger air bags are deployed, the following components must be replaced:• Driver and passenger air bag (inflator) modules [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL]
• Driver and passenger seat belt pretensioners
• SDM [MODULE,AIRBAG CONTROL]
• Driver / Passenger Forward sensors [AIRBAG SENSOR,FENDER]
• Instrument panel
When side-air bag and side curtain"air bag are deployed, the following components must be replaced:
• Deployed side-air bag (inflator) module [AIRBAG,FRONT SEAT]
• Deployed side curtain-air bag (inflator) module [AIRBAG,ROOF]
• Side-sensor [AIRBAG SENSOR,SIDE]
• SDM [MODULE,AIRBAG CONTROL]
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
Inspect all air bag system components including the electrical harness and the areas where they are mounted, even if the air bag system was not activated. Any components deformed or otherwise damaged must be replaced.• Steering column and shaft joints
• Steering column bracket and capsules
• Steering wheel and driver air bag (inflator) module
• Contact coil
• Instrument panel member, reinforcement and knee bolster and panel (driver and passenger)
• Passenger air bag (inflator) module
• SDM [MODULE,AIRBAG CONTROL]
• Air bag wire harness and connections
• Forward-sensor
• Side-sensor
• Seat belt pretensioner
• Seat belts and mounting points
• “AIR BAG” warning light
• OCM (Occupant Classification Module) with sensor mat
• Side-air bag (inflator) module assy
• Side curtain-air bag (inflator) module
• Do not try to repair the Air bag wire harness in main harness, instrument panel harness, floor harness, passenger air bag harness and seat harness
• If replacing seat belt is necessary, replace buckle and seat belt assembly together as a set.
• Any components deformed or otherwise damaged must be replaced.