OEM Restraints System Part Replacement Search

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

1. Turn ignition switch to OFF
2. Disconnect the negative
cable from the battery
3. Wait at least 3 minutes before beginning work

Before removing any of the SRS parts (including the disconnection of the connectors), always disconnect the SRS connector

REV: 04/2025

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

When the front airbag(s) deployed after a collision, replace the following items:
• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG,STEERING WHEEL; AIRBAG,KNEE BOLSTER; AIRBAG,INSTRUMENT PNL]
• Seat belt pretensioner(s)
• Front impact sensors [AIRBAG SENSOR,FRONT]
• SRS wiring harnesses

When the side/curtain airbag(s) deployed after a collision, replace the following items:
• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG & SEAT BACK ASSY; AIRBAG & SEAT ASSY,RR; AIRBAG,ROOF]
• Side impact sensor(s) for the deployed side(s) [AIRBAG SENSOR,SIDE; AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,QTR PANEL]
• SRS wiring harnesses
• When the front side airbag deployed after a collision, replace the seatback as an assembly
• When the rear side airbag deployed after a collision, replace the rear side seatback as an assembly.
• After the vehicle is completely repaired, confirm the SRS airbag system is OK

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

• Steering wheel
• Inspect the clock spring for heat damage
• Airbag connectors
• OCS
• After the vehicle is completely repaired, confirm the SRS airbag system is OK