OEM Restraints System Part Replacement Search


2019 Hyundai Veloster

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

Before doing any SRS repairs, use the GDS Pro to check for DTCs. Refer to the Diagnostic Trouble Code list for
repairing of the related DTCs.

1. Turn ignition switch to OFF
2. Disconnect the battery negative cable from battery
3. Wait at least 3 minute

Before removing any of the SRSCM parts (including the disconnection of the connectors), always disconnect the SRSCM connector.

REV: 10/2021

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

When the front airbag(s) deployed after a collision, replace the following items:

• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL]
• Front, Rear seat belt pretensioner (s)
• Anchor pretensioner(s)
• Front impact sensor [AIRBAG SENSOR,FRONT]
• SRS wiring harnesses

NOTE: Replace the crash pad which that has been damaged after the PAB has been deployed

When the side/curtain airbag(s) deployed after a collision, replace the following items:

• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG & SEAT BACK ASSY; AIRBAG,ROOF]
• Side impact sensor(s) for the deployed side(s) [AIRBAG SENSOR,SIDE; AIRBAG SENSOR,FRT DOOR]
• SRS wiring harnesses
• Front, Rear seat belt pretensioner(s)
• Anchor pretensioner(s)

NOTE: Make sure that the seat back cover is installed properly. Improper Installation may prevent the proper deployment

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

Before doing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs.

• Steering wheel
• When the front airbag(s) deployed after a collision,
• Inspect the clock spring for heat damage. If any damage found, replace the clock spring.
• After the vehicle is completely repaired, confirm the SRS airbag system is OK

Additional Information


*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.


Related I-CAR Courses