OEM Restraints System Part Replacement Search
2018 Mitsubishi Eclipse Cross
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
WARNINGService or maintenance of any SRS component or SRS-related component must be performed only at an authorized MITSUBISHI dealer.
1. Turn the ignition key to the "LOCK" (OFF) position
2. Disconnect the negative (-) battery cable from the battery and tape the terminal to prevent accidental connection and air bag(s) deployment
3. Wait at least 60 seconds after disconnecting the battery cable before doing any further work.
REV: 08/2022
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
DRIVERS, FRONT PASSENGER’S, KNEE AIR BAGS AND SEAT BELT WITH PRE-TENSIONER ARE DEPLOYED:• SRS-ECU [MODULE,AIRBAG CONTROL]
• DRIVERS air bag module [AIRBAG, STEERING WHEEL], [if deployed]
• Passenger’s (front) air bag module [AIRBAG, INSTRUMENT PNL], [if deployed]
• Knee air bag module [AIRBAG,KNEE BOLSTER]
• Seat belt with pre-tensioner, [if deployed]
• Front impact sensor [AIRBAG SENSOR,FRONT]
• Passenger’s (front) air bag lid assembly
• Front passenger’s seat cushion assembly (occupant classification-ECU) [CUSHION,FRONT SEAT]
• Seat slide sensor
WHEN SIDE AND CURTAIN AIR BAGS DEPLOY IN A COLLISION:
• SRS-ECU [MODULE,AIRBAG CONTROL]
• Headlining [HEADLINER]
• Front seat assembly [if deployed]
• Curtain air bag module, [AIRBAG, ROOF] [if deployed]
• Side impact sensor (front) [AIRBAG SENSOR,SIDE]
• Seat belt with pre-tensioner
• Front pillar trim, center pillar trim upper, quarter trim upper
WHEN CURTAIN AIR BAGS DEPLOY IN A COLLISION:
• SRS-ECU [MODULE,AIRBAG CONTROL]
• Headlining [HEADLINER]
• Side impact sensors (rear) [AIRBAG SENSOR,QTR PANEL]
• Curtain airbag modules [AIRBAG, ROOF], [if deployed]
• Front pillar trim, center pillar trim upper, quarter trim upper
WHEN CURTAIN AIR BAGS DEPLOY AND SEAT BELT PRE-TENSIONER OPERATE IN A COLLISION:
• SRS-ECU [MODULE,AIRBAG CONTROL]
• Headlining [HEADLINER]
• Side impact sensors (rear) [AIRBAG SENSOR,QTR PANEL]
• Seat belt with pre-tensioner, [if deployed]
• Curtain airbag modules [AIRBAG, ROOF], [if deployed]
• Front pillar trim, center pillar trim upper, quarter trim upper
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• Perform SRS-ECU memory check• Check the SRS components. If the SRS components are showing any visible damage such as dents, cracks, or deformation, replace them with new ones
DRIVERS, FRONT PASSENGER’S, KNEE AIR BAGS AND SEAT BELT WITH PRE-TENSIONER ARE DEPLOYED:
• Clock spring
• Seat belt switch
• Steering wheel, steering column assembly
• Instrument panel assembly
• Check the wiring harness for binding, the connector for damage, and the terminal for deformation
WHEN SIDE AND CURTAIN AIR BAGS DEPLOY IN A COLLISION:
• Headlining
• Front pillar trim, center pillar trim upper, quarter trim upper
• Check the wiring harnesses for binding, the connectors for damage, poor connections, and the terminals for deformation
WHEN CURTAIN AIR BAGS DEPLOY IN A COLLISION:
• Headlining
• Quarter trim upper
• Check the wiring harnesses for binding, the connectors for damage, poor connections, and the terminals for deformation
WHEN CURTAIN AIR BAGS DEPLOY AND SEAT BELT PRE-TENSIONER OPERATE IN A COLLISION:
• Check the wiring harnesses for binding, the connectors for damage, poor connections, and the terminals for deformation
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.
