OEM Restraints System Part Replacement Search
2018 Toyota YARIS HATCHBACK
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
When troubleshooting the SRS, always inspect DTCs before disconnecting the battery.Before using an electric welder on the vehicle, remove any SRS parts around the area being repaired
1. Turn ignition switch OFF
2. Disconnect negative (-) cable
3. Wait at least 90 seconds
REV: 11/2019
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
When the SRS parts are deployed (including when only an airbag or pretensioner is deployed) due to a collision, be sure to replace all sensors in the damaged areas (anywhere in need of repair) and airbag sensor assembly. [AIRBAG SENSOR,FRONT; AIRBAG SENSOR,SIDE; AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,QTR PANEL; MODULE,AIRBAG CONTROL]• Driver's Airbag [AIRBAG,STEERING WHEEL; AIRBAG,KNEE BOLSTER], [if deployed]
• Passenger airbag assembly [AIRBAG,INSTRUMENT PNL], [if deployed]
• Front seat airbag [AIRBAG,FRONT SEAT BACK; AIRBAG,FRT SEAT CUSHION], [if deployed]
• If the side seat airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with a new one
• Curtain shield airbag assembly [AIRBAG,ROOF], [if deployed]
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
Even in the case of a minor collision when the SRS does not deploy, the following parts should be inspected. If a defect is found (e.g. cracks, dents or any other defects) in any of the housings, brackets or connectors, then replace the part with a new one.• Airbag sensor assembly
• Front airbag sensors
• Door side airbag sensors
• Side airbag sensor assembly
• Side No. 2 airbag sensor assembly
• Steering pad
• Lower No. 1 instrument panel airbag assembly
• Instrument panel passenger airbag assembly
• Curtain shield airbag assembly
• SRS seat cushion airbag assembly
• Front seat outer belt assembly
• Instrument panel
• Steering wheel
• Inspect the seat frame assembly with deployed seat cushion airbag
• OCS: Perform the zero point calibration and sensitivity check
• When an accident vehicle is brought into the workshop for repair, check the flatness of the floor where the front passenger seat is mounted
• As the SRS parts are very hot after being deployed, ensure that all wire harnesses and connectors around deployed SRS parts are not damaged.
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.
