OEM Restraints System Part Replacement Search
2019 Toyota Sequoia
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Turn ignition switch to OFF and remove key.2. Disconnect and isolate negative battery cable.
3. Wait at least 90 seconds.
When the cable is disconnected from the negative (-) battery terminal, the memory settings of each system will be cleared. Because of this, be sure to write down the settings of each system before starting work. When work is finished, reset the settings of each system as before. Never use a backup power supply from outside the vehicle to avoid erasing the memory in a system
REV: 01/2022
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
When any of the airbags have deployed due to the collision, be sure to replace all sensors in the damaged areas and center airbag sensor assembly. [AIRBAG SENSOR,FRONT; AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,QTR PANEL; MODULE,AIRBAG CONTROL][Deployed Airbag(s)]
• Steering pad, [AIRBAG,STEERING WHEEL]
• Driver side knee airbag assembly [AIRBAG,KNEE BOLSTER]
• Front passenger airbag assembly, [AIRBAG,INSTRUMENT PNL]
• Front passenger airbag assembly, [AIRBAG,KNEE BOLSTER]
• Front seat airbag assembly, [AIRBAG & SEAT ASSY,FRT]
• Curtain shield airbag assembly, [AIRBAG,ROOF]
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• Steering pad [AIRBAG,STEERING WHEEL]• Front passenger airbag [AIRBAG,INSTRUMENT PNL]
• Knee airbag [AIRBAG,KNEE BOLSTER]
• Curtain shield airbag [AIRBAG,ROOF]
• Front seat side airbag [AIRBAG & SEAT ASSY,FRT]
• Seat belt pretensioner
• Center airbag sensor [MODULE,AIRBAG CONTROL]
• Front airbag sensor [AIRBAG SENSOR,FRONT]
• Side airbag sensor [AIRBAG SENSOR,FRT DOOR]
• Rear airbag sensor [AIRBAG SENSOR,QTR PANEL]
• Occupant classification ECU
• Seat position airbag sensor
• Perform the zero point calibration and sensitivity check if the vehicle is brought to the workshop for repair due to an accident or a collision
• Steering wheel
• Instrument panel/ Instrument panel reinforcement
• Front pillar garnish and Headliner
• SRS wire harness/ connectors
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.
